7
INSTRUCTIONS FOR COMPRESSOR INSTALLATION
1. Locate the cab access panel/port under the cab at front right.
2. Locate compressor / valve assembly and thread the ¼” fi ng into port 2 of the valve.
3. Remove airfilter from compressor .
4. Place compressor (upside down) under the floor of the cab next to access panel/port and mark hole loca ons (x3) for moun ng. Valve
should be facing towards rear of tractor.
5. Inside the cab, remove the console access panel, and if required li the flooring, on the right side; next to the door and at the console.
**Adjust/move any items that may be in the same loca on as the 3 marked hole loca ons.
6. Drill (3x) holes and a ach compressor under the floor of cab. Make sure to install the (3x) rubber grommets to reduce vibra on.
CAB ACCESS
PANEL/PORT
CAB ACCESS
PANEL/PORT
COMPRESSOR / VALVE ASSEMBLY
7. Thread elbow fi ng with male 1/4” NPT thread from airfilter reloca on kit into compressor filter port.
8. A ach airline from airfilter reloca on kit to fi ng and route hose into the right console in the cab through the access panel/port in the
floor.
COMPRESSOR / VALVE ASSEMBLY
MOUNTED UNDER CAB
ELBOW FITTING
AND AIRLINE
RIGHT CONSOLE ACCESS
PANEL REMOVED
