A group of up to 80 Vivosun 1000W fixtures can be connected to both the main RJ11 port
and the auxiliary RJ11 port of the controller.
5. CONNECTING UP TO 160 LED FIXTURES
Switch the rotary knob on all flexstar 1000W Fixtures to "EXT" [external control].
Plug the RJ11 end of one of the provided controller cables into the RJ11 main port of
the controller.
If a two room setup is used or if more than 80 1000W fixtures have to be connected, plug
a second controller cable in the RJ11 aux port.
Plug the RJ11 end of the controller cable[s] into the input of a RJ11 splitter. Use an
interconnect cable to connect one output of the RJ11 splitter to the RJ11 port of the
LED fixture.
Use an interconnect cable to connect one output of the RJ11 splitter to the input of
the following RJ11 splitter.
Repeat this process to connect up to 80 1000W fixtures per group.
80
80
80
80
6.BULB HANDLING INSTRUCTIONS
Remove the magnetic bulb socket cover.
Hold the bulb from its base.
Align the terminals with the corresponding shapes in the socket.
Twist clockwise until it is fully seated.
Replace the magnetic bulb socket cover.
It is common for the bulb to have some wiggle between the outer jacket and the
base.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE USE OR
WORKING WITH THE FIXTURE.
•
•
•
•
•
•
It is not recommended to run the bulb for less than 3 minutes as this can cause issues
with the bulb. Please wear gloves to prevent leaving skin oil on the glass. Skin oil can
cause premature bulb failure.
7.1.1. Open both lamp holders by sliding them
outwards and away from the center of the fixture,
as shown in photo A.
7. INSTALLATION
7.1 LAMP INSTALLATION
