03
Step 4
Attach the feet (1) to the legs (2) using screws (A). Tighten with the 4x4 hex key (E).
Notice: the long end of supporting plate (5) (6) and feet (1) should be in the same direction.
04
Step 3
Step 5
Step 6
Connect the cables (8 & 9) to the control box (7) as shown in the diagram below.
Power port
Port for cable
connected to
the leg
Port for
handset
Attach the square washers (D) onto the center
of the support beam.
A
x8
E
4x4
E
2
1
A
Long end
1
E
4x4
B
8
Attach the handset (8)
to the bottom of table.
B
x2
3
Desk
2
B
x22
D
Install the tabletop to the support plates (5 & 6).
Adjust the tightness of 8 screws on the back of supporting beam (3) by using 4x4 hex key (E), make
sure the supporting beam can move freely to fit the actual size of your table. Tighten screws up after
adjusting.
9
7
8
1
2
B
B
x2
2
1
4
Install cable management plate (4), Loosen thumb screws to put cable management plate in and then
tighten up.
Installation 2: put control box (7)
on the cable management plate (4).
1
Installation 1: attach
the control box (7) to
the bottom of table
using screws (B).
Slide the plate
Tighten thumb screws up
