Flexim FLUXUS WD, Operating Instruction

Page: 100 / 174

12 Dismounting and disposal
12.1 Dismounting
FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
100
12 Dismounting and disposal
12.1 Dismounting
The dismounting is carried out in reverse order to its installation, see chapter 6.
12.2 Disposal
The measuring equipment has to be disposed in accordance to the applicable regulations.
Depending on the material, the corresponding parts have to be disposed in residual or special waste or recycled. For further
information, contact FLEXIM.
Warning!
Service works by unauthorized and unqualified personnel
This may result in personal or material damage or other dangerous situations.
→ Any work on the transmitter has to be carried out by authorized and qualified personnel.
Danger!
Working in mines or cramped confines
Risk of intoxication and/or asphyxiation because of emerging gases, risk of injuries because of cramped
conditions.
→ Wear the required personal protective equipment. Observe the applicable rules.
Warning!
Touching live parts
Electric shock or arc faults can led to severe injuries. The measuring equipment can be damaged.
→ Prior to any work on the transmitter (e.g., installation, dismounting, connection, start-up), the transmit-
ter has to be disconnected from the power supply. It is not sufficient to remove the internal fuse of the
instrument, see section 7.2.
Caution!
Safety and accident prevention regulations for electrical systems and equipment
Failure to observe these regulations may lead to severe injury or death.
→ Observe the safety and accident prevention regulations for electrical systems and equipment.