7 Connection
7.3 Outputs
FLUXUS G831ST-HT
2021-06-01, UMFLUXUS_G831ST-HTV1-0EN
60
7.2.1
Cable connection
• Remove the blind plug to connect the cable to the transmitter.
• Prepare the cable with an M20 cable gland.
The used cable has to have a wire cross-section of 0.25…2.5 mm².
• Push the cable through the cap nut, compression part and basic part of the cable gland.
• Insert the cable into the housing of the transmitter.
• Screw the sealing ring side of the basic part into the transmitter housing.
• Fix the cable gland by screwing the cap nut onto the basic part.
• Connect the cable to the terminals of the transmitter.
7.3
Outputs
• Connect the output cable to the transmitter (see 7.2.1, Fig. 7.11 and Tab. 7.7).
Fig. 7.10: Cable gland
1 – cap nut
2 – compression part
3 – basic part
Important!
The max. permissible voltage between the outputs and against PE is 60 V DC (permanent).
Fig. 7.11: Connection of the outputs to the transmitter
2
1
3
AR
AV
ARS AVS
BR
BV
BRSBVS
L
(+)
N
(-)
12
11
10
9
8
7
6
5
4
3
2
1
upper housing,
back view
lower housing,
front view
12
11
10
9
8
7
6
5
4
3
2
1
