8 Start-up
FLUXUS G809
8.2 Switching on
83
UMFLUXUS_G809V2-2EN, 2020-06-25
8.2
Switching on
As soon as the transmitter is connected to the power supply, it is displayed which transducer has been detected at which
channel.
Afterwards, the serial number of the transmitter is displayed for a short time.
It is not possible to enter any data while the serial number is displayed.
After switching on the transmitter, the main menu is displayed in the default language. The language can be changed.
Operation state indication
The operation state is indicated by LEDs above the display.
8.3
Program branches
The following schema shows the program branches. For a detailed overview of the menu structure see annex A.
1
SYSTEM settings
contains the following menu items:
• dialogs and menus
• measurement
• outputs
• storing
• snap
• network
• serial transmission
• miscellaneous
• clock settings
• libraries
Tab. 8.1:
Operation state indication
LED off
transmitter in idle state
LED lights green
signal quality of the measuring channel sufficient for a measurement
LED lights red
signal quality of the measuring channel not sufficient for a measurement
Parameter
Measuring
Options
Special Funct.
Selection of a measuring channel
Selection of measuring channels
Selection of a measuring channel
System settings
1
Pipe parameters
Measuring point number
Physical quantity
Instrument information
Fluid parameters
Number of sound paths
Unit of measurement
Print of measured values
Transducer type
Transducer positioning
Damping
Deletion of measured values
Length of extension cable
Measurement
Output of measured value
Program code
Consistency check
