3. Enter a 6-digit code. Ex.: ENTER => L1 will be on, with a short beep.
4. Enter the above code again to confirm the new code => Ex.: =>
ENTER => L1, L2 will be on for 4 seconds, with a long beep, and L1, L2 will be
off, implying the Installation Code has been successfully changed.
Set a Channel Code
1. Press ENTER + Installation Code + ENTER => L1, L2 will be on for 3 seconds,
with a long beep, and L1, L2 will be off.
2. Press 2 + ENTER => L2 is on, with 2 short beeps, and L2 remains on, entering
Channel Code Setting Mode.
3. Select a desired Channel Number (1 ~9) + ENTER => there will be a short
beep, and L2 remains on.
4. Enter a desired Channel Code (1 to 8 digits) + ENTER => there will be a short
beep, and L2 remains on.
5. Enter the code again to confirm the Channel Code.
XX ENTER => L1, L2 will be on for 4 seconds, with a 4-second long
beep, and L1, L2 will be off along.
6. A second setting can overwrite a previously set Channel Code.
Delete a Channel Code
1. Press ENTER + 6-digit Installation Code + ENTER => L1, L2 will be on for 3
seconds, with a long beep, and L1, L2 will be off.
2. Press 2 + ENTER => L2 will be on, with 2 short beeps, and L2 will be on,
entering Channel Code setting mode.
3. Select a Channel Number(1~9) that you intend to ENTER
Channel ENTER => there will be a short beep, and L2 will be on.
4. Enter the command of deletion
Press 0 + ENTER => there will be a short beep, and L2 will be on.
5. Enter the above command again to confirm the deletion.
Press 0 + ENTER => L1, L2 will be on, with a 4-second long beep, and L1, L2
will be off.
Battery indication
1. The battery voltage is normal if you hear a beep when any single button is
pressed.
2. The battery voltage is about half-discharged if you hear 2 beeps when any
single button is pressed. No setting is available at this moment. Only RF
transmission is allowed.
3. The battery needs to be replaced if you hear 3 beeps.