Positive (DC+)
Negative (DC-)
INPUT: DC12V-24V
PAUSE
TOUCH PANEL
MODEL: T3-5A
REMOTE CONTROL
LED CONTROLLER
DC
DC
MODE
MODE
SPEED
SPEED
BRT
BRT
or
ColorBright™ RGB 150 Color Changing
ColorBright™ RGB 300 Color Changing
Positive (+)
Green
Red
Blue
Positive (+)
Blue
Green
Red
G
B
R
V+
I
2
3
4
5
6
7
8
MI
M2
9
*
I0
INSTALLATION
Always pre-test your LED setup prior to permanent installation. This will ensure all components work correctly. Be sure to check the amperage
rating of the LED strip you’ve purchased so the receiver isn’t overloaded (max 5 amps per channel). Turn off the main AC breaker for the line you’ll
be using before installing your low voltage power supply. If you experience any issues at all with your test set up, please be sure to contact us at
After Sales Support.
Loosen the Power DC+ and DC- screws and insert the red wire from
your low voltage non-dimmable power supply in the DC+ channel and
secure the screw. Then insert the black wire from the power supply in
the DC- channel and secure the screw.
Turn the main breaker for the AC line back on to power your non-dim-
mable power supply.
Look at your LED strip carefully and identify the positive (+), R, G, and B
channels.
Press the Power Button on the receiver, the LED strip will turn on.
Loosen the , B, G, and R screws. Then connect the + wire from
the LED strip to the V+ channel in the receiver and secure the screw. Do
the same to match the rest of the wires to their respective channels.
Press the Power Button on the remote control, the sync status indicator
light and the LED strip will turn on.
1.
2.
3.
4.
5.
6.
V.2018.11.01
RGB-MZ-COMBO
3
page
support@FlexfireLEDs.com
925-273-9080 opt 2
User Guide
•
RGB Multi-Zone Combo
