Flexcom Communication Ltd
Installation and operating instructions (2021/03/24)
17/25
Alarms
Different alarm functions can be set on the device for different types of events. When the event occurs, the device sends an SMS message to the
administrator's phone number, or you can also sound beeps on your speaker.
Beep
The operation of the beeps can be switched on or off with the following SMS commands:
Turning on
1.
Send hon# (horn on) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Turning off
1.
Send hoff# (horn off) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
You can set the alarm delay with the following SMS command: ntim,x# where x is the delay time in seconds.
Magnetic detection
The device can also be used to detect the opening of a door (or any door and window) using the included wall mount and magnet.
1.
Mount the wall bracket on the wall next to the door.
2.
Mount the magnet on the door.
3.
Slide the appliance into the wall mount from above.
To activate or deactivate the magnetic opening detection mode, the following SMS commands must be sent to the device:
Turning on
1.
Send the command don# (door on) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Turning off
1.
Send the command doff# (door off) to the phone number of the device via SMS.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Motion, vibration detection
The device can be set to send an alarm to the administrator's phone number in an SMS message when it is moved or vibration is detected. To
activate or deactivate the motion / alarm detection mode, the following SMS commands must be sent to the device:
Turning on
1.
Send the command von,x# (vibration on) via SMS to the phone number of the device, where x can be 1,2,3 or 4 - these can be used to control the
sensitivity of the sensor.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Turning off
1.
Send the command voff# (vibration off) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Sound detection
The device can also detect sounds and send an alarm. To turn the voice recognition mode on or off, send the following SMS commands to the
device:
Turning on
1.
Send non# (noise on) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Turning off
1.
Send noff# (noise off) via SMS to the phone number of the device.
2.
If the device has received and executed the command, confirm it by sending an SMS with OK.
Flexcom
