3.
Position rollers over hooks.
4.
Turn adjusting knob counter-clockwise
until rollers touch hooks.
6.
Using the handle, move the lacer head
across the belt width at a smooth speed.
5.
Return lacer head to end of lacer and turn
adjusting knob 1½ additional turns counter-
clockwise.
8.
Remove lacer pin. Release belt clamp.
Remove belt from lacer.
NOTE: The belt will need to be ‘continuous
laced’ if it is wider than the lacer.
7.
Turn adjusting knob counter-clockwise 1/2
turn and return head across the belt. Repeat
until hooks are embedded 1/3 to 1/2 into the
belt.
Continuous Lacing:
DRIVE
HANDLE
Turn knob 1½
turns counter-
clockwise
1/2 to 1/3 of the wire
diamater should be
embedded into the belt.
• Wipe debris off chain-body extrusion periodically with a dry cloth to prolong the UHMW guide life.
• If head begins to rock back and forth, visit www.flexco.com for instructions on adjustment techniques.
Maintenance:
CONTINUOUS
LACING SLOTS
FIRST ACTIVE SLOT
1.
Starting on one side of the belt, lace the first section using the ‘Lacer Operation’
instructions listed above.
2.
Open rollers.
3.
Insert hooks into face strip, starting with the first active slot.
4.
Insert lacer pin. Remove carding paper from hooks, if applicable.
5.
Guiding belt through the belt clamp, position laced hooks into the continuous lacing
slots, directly next to the first active slot. Keep belt flush against the face strip. Clamp
belt.
6.
Lace this section using Steps 3-8 of the ‘Lacer Operation’ instructions.
Helpful Tip: When continuous lacing it is recommended to lace the shorter length of
belt first and then continue with the longer section of belt. Example: when using a 24"
Roller Lacer to lace a 36" wide belt, lace the 12" section of belt first and then follow
the process to continuous lace the remaining 24" of belt.
Lacer Operation (cont.):
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 • USA
Tel: (630) 971-0150 • Fax: (630) 971-1180 • E-mail: [email protected]
Visit
www.flexco.com
for other Flexco locations and products.
©2008 Flexible Steel Lacing Company. Clipper
®
, Roller Lacer
®
and Microlacer
®
are registered trademarks.
10-23-17. For Reorder: X1452
