Installing Clipper
®
Fasteners with
the Roller Lacer
®
and Microlacer
®
1.
Square belt end off centerline.
2.
Select the proper size hook for your
application.
3.
If belt has an impression cover, skive back
1
"
(25mm) from the belt end.
Prepare Lacer for Use:
Belt Preparation:
Face Strip Installation
2.
Position lacer head to the end of the tool.
Turn knob clockwise to open rollers.
B
C
3.
Insert hooks into the first active slot of the
face strip. Secure with lacer pin.
4.
If using hooks as shown in A or B, remove
carding paper at this time. If using hooks
as shown in C, remove carding paper after
installing hooks.
1.
Loosen hex screw to allow Face Strip
Retaining Latch to rotate out of the way.
Insert Face Strip, reposition Latch and
tighten screw.
HEX SCREW
LATCH
CONTINUOUS
LACING SLOTS
ADJUSTING KNOB
FIRST ACTIVE SLOT
Lacer Operation:
2.
Lock belt clamp.
1.
Guide belt through clamp; insert belt end
into hook points and flush against the entire
width of the face strip.
ROLLER LACER
1
1
2
2
3
3
4
4
A
A
B
B
C
C
D
D
TITLE
SIZE
DWG NO
REV
SCALE
SHEET
OF
DRAWN
CHECKED
QA
MFG
APPROVED
1
1
C
TVandeVegte
2/20/2004
MICROLACER
For Roller Lacer Serial Nos. 60000+; Microlacer Serial Nos. 40000+
A
Belt clamp
knob
