Polisher L3403VRG
18
Maintenance and care
Danger!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
Danger!
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing.
Impairment of the protective insulation!
Operate the power tool via a residual-
current-operated circuit-breaker (tripping
current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches
off automatically.
Note!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the
guarantee obligations of the manufacturer
will be deemed null and void.
When the polisher is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes spark excessively,
switch off the polisher immediately. Take the
polisher to a customer service workshop
authorised by the manufacturer.
Gears
Note!
Do not loosen the screws on the gear head
(5) during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer’s
catalogues.
Spare-part/Accessory
Order
no.
FLEXgrip handle
292.354
Bail handle
298.506
Metal carrying case
303.224
Velcro pad 125 mm with
centring tube
258.705
Velcro pad M14, soft, with
rubber damper; 125 mm
231.983
Backed fleece M14, 125 mm
122.726
Molleton buffer, 125 mm
123.749
Book_Heft3.book Seite 18 Donnerstag, 29. Juni 2006 3:48 15
Summary of Contents for L3403VRG
Page 1: ...L3403VRG 317 535 06 06 ...
