11
INSTALLATION
Park your vehicle on a flat level surface.
Turn off the engine before installing the
FF
2000.
Attach the
FF
2000 using the provided double sided 3M tape.
The surface must be clean and dry before you install. We recommended to install
the product behind the rear view mirror on the front windshield.
NOTE: The 3M adhesive tape will not stick well with dust or oil, etc.
Please make sure the surface is clean before applying.
Adjust camera view. Make sure the lens has an unobstructed view. Check from
outside the vehicle to check the camera angle, you can adjust the angle via the
bracket teeth.
Arrange the power cord neatly alongside of the windshield and door pillar trim.
The
FF
2000 requires a continuous 12/24volt power source from the vehicle.
The cable supplied will allow you to hard wire the
FF
2000 unit to the fuse box of
your vehicle.
Connect the “red cable (+)” to a fuse (see picture below). It should be connected
to a fuse that has power when you start the engine.
The ground cable should be contacted at the car body or battery negative.
Start on the car after installation.