Help: 888-426-5001
2 ›P l aC I n G a n d FI l l I n G t H e ta n k
1) Choose the final location for your water softener
tank and place the tank upright and level on the
surface. Filling the tank may be necessary on
some systems. Your tank may have also come
pre-filled, and in this case you only need to un-
screw the protective cap as shown in
Figure 6-a
2)
If your tank is not filled
, place the riser tube
into the tank as shown in
Figure 6-B
. Please
make sure that the riser tube seats into the
bottom of the tank and that the top of the tube is
flush with the top of the tank opening
F I G u R e 6 - a
F I G u R e 6 - B
›PR e - I n s ta l l at I o n
Before assembly of your new system, be sure that the following conditions have been met for the place-
ment of your system:
•
Level, firm surface, such as concrete, on which
to place the softener tank and salt tank (also
known as a
brine
tank)
•
Un-switched power source, standard US plug,
120v 60hz (the softener system includes a
5 ft power cord and plug)
•
Access to the water main coming into your
home. You will need to install the softener at
this point to assure that water for the home is
going through the system
•
Nearby floor drain or standpipe to connect to the
softener for use during each regeneration
Well
Pump or
City
Meter
Water
Heater
Bypass
Bath
Sink
Toilet
Kitchen
Spigot
Spigot
Softener
Drain Line
Hard Water
Soft Water
Overflow
(Optional)
Floor
Drain
