Operation and installation manual
Operation and installation manual
DISHWASHERS
11
Rinsing agent doser control
Within the last rinsing cycle, a certain
amount of the rinsing agent is used. Similar
to use of the detergent agent, the quantity of
the rinsing agent depends upon water hard-
ness. If you use too much rinsing agent, this
may lead to excessive foaming and occur-
rence of stains on your dishes. If water in
your location is soft, you will need no rinsing
agent. But if you still need that, dilute it with a
corresponding amount of water.
The doser has 6 positions. Always start
with Position 2. If the dishes dry out badly, if
there are drop marks on them, increase the
amount of the rinsing agent, switching to Po-
sition 3. Continue to increase the amount, till
there are no drop marks on your dishes. We
recommend using Position 4.
How to fill in the doser
with the rinsing agent
If the control panel does not include an
agent level control lamp, you can calculate
a required amount of the rinsing agent in the
following way. The black spot decreases in
size with the liquid volume decrease. The
level below ¼ is not permitted.
Depending upon consumption of the rins-
ing agent, the size of the black spot decreas-
es in size (see the figure):
Full
3/4
1/2
1/4 - refilling required
Empty
