6
USERS GUIDE
Lighting the stove
1
Reach through the aperture in the rear access door and turn on the gas by turning the
switch on the regulator upwards.
2
Depress the control knob and turn it fully clockwise. Keep the control knob fully
depressed and rotate it fully anticlockwise. This will operate the spark generator (you
will hear a ‘click’) and allow gas to flow to the burners. The pilot burner and the main
burner should light. If they do not ignite repeat the operation. Check that the pilot
burner has lit (it can be viewed, or its reflection can, by looking at the lower right hand
side of the glass door.) If the stove is new or has not been used for some time the main
burner will light before the pilot burner. In this case the pilot burner may not light from
the main burner and the knob will have to be released and the burners relit.
3
Once the burners are both alight hold the control knob down for a further 15 seconds
and then release. The burners should stay alight. If they do not, repeat the lighting
procedure only holding the knob down for longer.
4
Once the burner is alight the control knob can be turned further anticlockwise to go to
the high fire setting and clockwise to low fire. If the stove does not light on the second
try, wait three minutes before attempting to light the appliance again. This is to allow
any gas vented in the first two attempts time to disperse.
5
To turn the appliance OFF, reach through the aperture in the rear access door and turn
off the gas at the bottle by turning the switch on the regulator downwards to a
horizontal position.
VERTICAL / ON
HORIZONTAL / OFF
Regulator
LOW FIRE
HIGH FIRE
The Control Knob