Flavel FCF5050, Operating Instructions Manual

Page: 5 / 32

3
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your
electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a
suitable switched and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped
or damaged.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead
which can only be obtained from a
FLAVEL
Authorised Service
A
gent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the
fi
tted moulded plug is not suitable for your socket, then the plug should be cut
off and an appropriate plug
fi
tted. Destroy the old plug which is cut off as a plug with
bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTABEAB approved BS 1362 fuse of the same rating must
be used. Do not forget to re
fi
t the fuse cover. In the event of losing the fuse cover
the plug must not be used until a replacement fuse cover has been
fi
tted. Colour of
the replacement fuse cover must be the same colour as that visible on the pin face
of the plug. Fuse covers can be obtained from a authorised service agent.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in themains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug
proceed as follows: (See diagram).
1. Connect the green-yellow or green (Earth) wire
to the terminal in the plug marked 'E' or with the
symbol or coloured green and yellow or green.
2. Connect the blue (Neutral) wire to the terminal
in the plug marked 'N' or coloured black.
3. Connect the brown (Live) wire to the terminal in
the plug marked 'L' or coloured red.
With alternative plugs a 13A fuse must be
fi
tted either in the plug or adaptor or in the main fuse box.
If in doubt contact a quali
fi
ed electrician.
WARNING: Do not locate extension sockets or charging transformers/power supplies
or Lithium-Iron battery operated products adjacent to the compressor as
they could overheat.