6
REMOVAL & REFITTING OF THE GLASS FRAME.
a)
Remove the fascia & ashpan cover from the firebox.
b)
Remove the pilot heat shield which is held in place at each end by 1 screw.
c)
Remove the top infill panel by sliding it upwards out of the clips.
d)
Obtain the allen key which is located at the bottom left hand side of the firebox.
e)
Loosen each allen bolt a small amount at a time to prevent damage to the glass
panel. When all the allen bolts have been removed, lift away the glass frame and
clean as per the previous page.
f)
Refit the glass panel to the firebox, again tightening each bolt a small amount at a
time to prevent stressing the glass panel. Fully tighten all the bolts to ensure good
compression on the glass panel.
g)
Refit the fascia & ashpan cover to the firebox.
4 Allen key
fixing screws
Top infill panel.