Flashforge Inventor, Quick Start Manual

Page: 3 / 36

10. Remove the foam from the back of the logo
board.
11. Hold both sides of the printer, lift up the printer
slowly, thus removing filament under build
plate easily. Do not make build plate collide
with extruder.
8. Remove bubble bag outside the extruder, put
extruder on the extruder mounting base.
Notice: The extruder should be put as is shown
(extruder fan should towards the front of the
printer)
7. Open the paper box on the top of the printer,
there is an extruder, two side panels and an
extruder's accessory kit inside. Take the
extruder and the paper box out, notice that
the cable bunch connected with extruder is
short, do not hang the extruder in the air.
02
9. Shear three ties off on both sides of X-axis guide rod.