InventorIIS User Guide | www.flashforge.com
20
[Filament Check] Off:
The filament detection is
turned off
.
Note: Filament exhausted or interrupted
cannot be detected.The print job can still
work normally when filament is not set
into the filament cartridge.
[Door Opened Pause] On:
If printer front door is opened during
printing, door opened pause hint will pop
out on printer touch screen.
[Door Opened Pause] Off:
If printer front door is opened during
printing, door opened pause hint will not
pop out on printer touch screen.
[Power Saving Mode] On:
The power saving mode status is turned
on
.
If there is no operation within half an
hour, the printer will automatically shut
down. (Power saving mode will not work
in the process of printing)
[Power Saving Mode] Off
The power saving mode status is turned
off. Automatically shut down will not
work.
Turn on/off [Light Bar Control]:
Tap to turn on/off the
light bar.
Factory Reset
：
Return to factory
setting.
Update: To update the firmware
version.
Back
