LED Virtuozo Moving Head F7100077
www.flash-butrym.pl
5
DMX-512 connection with DMX terminator:
For installations where the DMX cable has to run a long distance or is in an electrically noisy environment,
such as in a discotheque, it is recommended to use a OMX terminator. This helps in preventing corruption
of the digital control signal by electrical noise. The OMX terminator is simply an XLR plug with a 120 Q
resistor connected between pins 2 and 3, which is then plugged into the output XLR socket of the last fixture
in the chain. Please see illustrations below.
5.1
Voltage specification
Input Voltage
Total Power
Frequency
90~260V
400W
50/60Hz
5.2
Connecting power supply
The connection is performed using power cable with PowerCon connector (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION! In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
6
MAINTENANCE AND CLEANING
The following points have to be considered during the inspection:
1.
All screws for installing the devices or parts of the device have to be tightly connected and must
not be corroded.
2.
There must not be any deformations on the housing, color lenses, fixations and installation
spots(ceiling, suspension, trussing).
3.
Mechanically moved parts must not show any traces of wearing and must not rotate with
unbalances.
4.
The electric power supply cables must not show any damage , material fatigue or sediments.
5.
Further instructions depending on the installation spot and usage have to be adhered by a skilled
installer and any safety problems have to be removed.
CAUTION! Disconnect from mains before starting maintenance operation.
