www.flash-butrym.pl
2
1
INTRODUCTION
Thank you for purchasing LED Moving Head 120W SPOT MK2. For safety reasons and to ensure the trouble-
free operation, carefully read the instructions.
2
SAFETY INFORMATION
2.1
General information
1.
Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock.
2.
Disconnect the power supply before installation.
3.
Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4.
Do not use the device in high humidity conditions and at temperatures above 40° C
5.
The device must be installed on stable structures.
6.
Please keep this user guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
7.
Always make sure that you are connecting to the proper voltage, and that the line voltage
you are connecting to is not higher than that stated on the decal or rear panel of the fixture.
8.
This product is intended for indoor use only!
9.
To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure that
there are no flammable materials close to the unit while operating.
10.
The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from
adjacent surfaces. Be sure that no ventilation slots are blocked.
11.
Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse size and type.
12.
Secure fixture to fastening device using a safety chain.
13.
Never carry the fixture solely by its head. Use its carrying handles.
14.
In case of a serious operating problem, stop using the unit immediately. Never try to repair
the unit by yourself.
15.
Repairs carried out by unskilled people can lead to damage or malfunction. Please contact
the nearest authorized technical assistance center. Always use the same type spare parts.
16.
Don't connect the device to a dimmer pack.
17.
Make sure the power cord never crimped or damaged.
18.
Never disconnect the power cord by pulling or gagging on the cord.
19.
Avoid direct eye exposure to the light source while it is on.
2.2
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the
fixture or referred to the fixtures specification chart. A fixture listed current rating is its average current draw
under normal conditions. All fixtures must be directly powered off switched circuit and cannot be run off a
rheostat (variable resist) or dimmer circuit, even if the rheostat or dimmer source voltage matches the
fixtures requirement. Check the fixture or device carefully to make sure that if a voltage selection switch
exits that it is set to the correct line voltage you will use.
