www.flash-butrym.pl
Strona 2
Thank you for having chosen our company’s products. For your own safety, please read this user
manual carefully before installing the device.
SAFETY INTRODUCTION
If the device has been exposed to temperature changes due to environmental changes, do not
switch it on immediately. The arising condensation could damage the device. Leave the device
switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed. A
qualified person must carry out the electric connection.
Make sure that the available voltage is not higher than stated at the end of this manual.
Never operate the stroboscope without glass pane or with a broken glass pane. Ask your dealer or
authorized agent to replace the glass pane.
Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or
authorized agent to replace the power cord.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power cord by plug. Never pull out the plug by tugging the power cord.
During initial start-up, some smoke or smell may arise. This is normal and should decrease
gradually.
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous voltage you can
suffer a life-threatening electric shock when touching live wires.
2. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
3. Please be aware that damages caused by manual modifications to the device are not subject to
warranty. Keep away from children and non-professionals.
GENERAL GUIDELINES
This device is a stroboscope for decorative effects. This device is only allowed to be operated with
and alternating current of max. 220VAC/50
Hz
/60Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating it.
When choosing the installation spot, please make sure that the device is not exposed to extreme
heat, moisture or dust. The minimum distance between light-output from the projector and the
illuminated surface must be more than 0.5 meter.
Operate the device only after having familiarized yourself with its functions. Do not permit operation
by person not qualified for operating the device. Most damages are the result of unprofessional
operation.
Please use the original packaging if the device is to be transported.
For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore,
any other operation may lead to short-circuit, burns, electric shock, lamp explosion, crash, etc. If
this device will be operated in any way different to the one described in this manual, the product
may suffer damages and the guarantee becomes void.