FlameStop VESDA-E VEU-A10, Product Manual

Page: 57 / 116

VESDA-E VEU-A10 Product Guide
www.xtralis.com 51
2. Enter a unique name for the Connection or accept the pre-generated name, then select Finish
(Figure 5-4).
Figure 5-4: Enter a Connection Name
Adding an Ethernet or WiFi connection
1. Select Ethernet / WiFi , then select Next (Figure 5-5).
Figure 5-5: Select Ethernet
2. Enter the IP address of the detector. Enter the password that has been set for Ethernet and WiFi
authentication. Select Next (Figure 5-6).
Note: The IP address and password of the detector is configured in the Ethernet or WiFi options
section during initial setup with a USB connection. Refer to Section 5.5.3 on page 62 or 5.5.4
on page 64 for further information.
Figure 5-6: Enter IP Address