2 |
P a g e
Using as Wall Mounted:
The fire comes with two hanging rails, top and bottom to enable fixing the Glazer to the wall. Although your preference,
we recommend no lower than 400mm from the bottom of the fire opening to the floor so the bottom bracket should be fixed 290mm or above
from the floor. Mark the holes, drill and fit the rawl plugs using an M10 bit. Using the 60mm screws fix the bracket to the wall.
Position the fire on top of the bottom bracket making sure the corner bolts fit through the slots either side and can screw into the underside of the
fire. With the top bracket attached to the fire, mark across its length and into the slots above each hole on the back edge. Remove the fire,
remove the top bracket and 13mm screws from the fire and mark the holes on the wall, drill and fit the rawl plugs using an M10 bit. Using the
60mm screws fix the bracket to the wall.
Slide the fire into the channel created by the top and bottom brackets. Screw the top bracket back onto the fire with the 13mm self-tappers and
bolt each corner of the bottom bracket threw the slots either side into the fire using the M6 bolts and washer supplied. At this point you will be
able to level the fire accordingly at the base by loosening and tightening the bottom bolts.
Fitting the Glass:
A:
Push the side glass back towards the rear of the case
B & C:
You will notice there is a long gap on the underside of the opening 10mm in width that runs along and in front of the heater grills. At an
angle of approximately 45 degrees push the glass up into this void making sure the bottom of the glass clears the lower edge of the opening. Tilt
the glass back into the fire and carefully lower into the large channel that runs across the opening avoiding the dampers.
