Page 3 of 4
OPERATING THE FIRE
Controls: The fire can be operated either by manual or remote control. There is a main on/off switch top right of the fire, this is marked
with I/O and will need to be switched to I (standby) to operate the fire. In the O position (off) you will be unable to operate the fire.
Fig 4
Fig 5
1.
To turn the fire on (Fig 4 and Fig 5), simply press and release the FIRE ON
button on the remote or manual keypad.
2.
To set the inner flame & fuel effect to your desired brightness press + or - buttons marked DIMMER1 or
1.
3.
To set the outer flame & fuel effect to your desired brightness press + or - buttons marked DIMMER2 or
2.
4.
To activate or deactivate the outer flame & fuel flicker function press and release button Flicker. The flicker function will always
deactivate once the fire is turned off.
5.
*
For heating the fire must be switched on and the glass tilted to its back position by pushing the handle in the top right of the screen
briefly inwards. To give 1kw of heat, press then release the button marked ON/OFF HEAT
O/I. To increase the temperature to 2kw
press then release button marked HI/LO or
I/II. You may alternate from 1kw to 2kw by pressing HI/LO
I/II at anytime. To turn
the heater off, press then release the button marked ON/OFF
O/I. The heater will always start in the lower setting
6.
To turn the fire to standby press then release the button marked FIRE OFF
.
7.
To turn the off depress the main on/off switch to the O position
Setting time on remote control: On the remote control turn the fire off so the only symbol
. Hold down Flicker & lower
1 (-)
buttons at the same time for three seconds and the hour will flash. Use
2 + or – buttons to set hour noting that there is an AM /PM
suffix. Press Flicker again to move on to minutes and again use
2 + or – buttons. Finally press Flicker again to set the time.
*Important: Do not open and close the glass repeatedly while the heater is on or the cut out will activate.
Automatic safety cut out: The heater is fitted with an automatic cut out to prevent any damage due to overheating. The element
will continually and automatically cut out if the airflow is obstructed. Never cover the air inlets or outlets. To reset, switch the fire
off, disconnect from the mains supply, remove the cause of overheating and allow to cool for a suitable period then switch the fire
back on. Caution: In order to avoid a hazard due to inadvertent resetting of the thermal cut out, the appliance must not be supplied
through an external switching device, such as a timer, or connected to circuit regularly switched on and off by a utility.
Areas around the fire will become hot when activated. We strongly recommend small children be kept away from having any direct
contact with the appliance by means of fitting a fireguard. This appliance is not intended for use by persons (or children) with reduced
physical sensory or mental capabilities or lack of experience or knowledge unless they have been given supervision or instruction
concerning the use of the appliance by the person responsible for their safety. Children should be supervised to ensure they do not
play with this appliance.
