6
3. Handling
For beginning the record sequence please push the REC button (blinking LED). You can record
the movements of the ruler until you push again the button REC or until up to the maximal
record time. Now the record sequence stops and jumps automatically in the Play loop mode
(LED on). The sample rate is about 250Hz.
From mode STOP or PLAY you can start a record sequence anytime.
The maximum recording time per channel is about 2 minutes.
Please note
: not the signal at the inputs is recorded, but only the volume control of the poten-
tiometers!
After switching on, the module is in STOP mode. All LEDs are off. With the respective potentio-
meter of the track you can now mix between the two adjacent signals of the channel, which is
then applied to the MIX output. If the potentiometer is on the left stop, the signal of input 1 appe-
ars on the Mix output, the signal on input 2 appears on the right. The two signals are mixed in
between.
In this mode, the module behaves like an ordinary dual audio / CV crossmixer with two inputs to
a MIX output.
Since the mixer is internally equipped with VCAs, the mix control per channel can be recorded
separately for up to two minutes and played back later.
After a record sequence the play back of the track starts automatically in loop (LED on). If you
are in mode STOP (LED off) then you can start the play back with pushing the button PLAY.
Please note the both versions of pushing (short or long):
ONE SHOT
- Track plays once only: Push the button shortly (< 0,5sec)
PLAY LOOP
- Track plays in loop: Push the button longer (> 0,5 sec)
ATTENTION:
Reset can start the track (or tracks) while Play mode is activated (LED on).
3.2 Record
3.1 Manual mix mode (Stop)
3.3 Play back
