FlaggerJoe Assembly Instructions
Item: FJ-SSUMB10 - Safety Sign System
A = Umbrella Canopy
B = Lower Umbrella Pole
C = Double Flag Finial
D = Flags (2)
E = Sign Mount
F = 34” Black PVC Post
G = Extra Top Pole for Wind
H = Carry / Storage Bag
J = 24” Black PVC Post
K = Rolling Base
Step 8
Connect umbrella canopy (A) with lower umbrella pole (B) by either lifting the
umbrella off the ground and inserting the top pole into the bottom pole or move
the rolling base over to the umbrella pole and connect while on the ground.
Make sure button pops out of hole in the side of the lower umbrella pole (B)
Step 9
Stand the umbrella up.
Step 10
Inspect the double flags to make sure they are visible to oncoming traffic. If out
of position, tilt the umbrella down and re-
position by rotating “C”. See Figure 5.
Questions: Call Customer Service at 888-329-3436
Use “G” when wind is present
x2
Note:
“E” ships separately
Note:
“J” and “K” ship separately
Note: 40lb Sand Bag/Weight required but not included
Figure 5
Step 11
Insert Stop/Slow signs on to sign mount (E). The center arm is spring loaded and will lift
upwards. With one hand positioned on the bottom of the sign and the other hand holding the
34” black pvc post (F) in place - push the sign up into the center
slot of the upper arm. The arm will move upwards allowing for the bottom of the
sign to drop into the lower arms. See Figure 6.
Step 12
Add 40lb Sand Bag/Weight to the Rolling Base.
Step 13
When job is complete, store parts and all other
components in FlaggerJoe carry/storage bag (H).
NOTE:
Intended Use Statement
Remove canopy when winds exceeds 10
– 15 miles per hour.
Never position the drop down sun flap towards oncoming traffic
When wind is present, never leave FlaggerJoe unattended.
Figure 6
Push Sign Up Into Place
BACK
Finished Assembly
BACK PAGE
Note: Stop/Slow Signs Not Included
