Flaem AS01P00, Instructions For Use Manual, Page: 18 / 96

16
TROUBLE-SHOOTING
Switch off the device before any procedure and unplug the power cable from the socket.
PROBLEM CAUSE SOLUTION
The device does not work
The power cable has not been correctly in-
serted into the socket of the device or the
power socket
- Correctly insert the power cable into the
sockets
Lack of suction
The collection cannister lid has not been
correctly positioned onto the cannister - Correctly position the collection cannister
lid
Lid gasket not in place - Correctly position the gasket on the lid
Lack of suction caused by fluid leakage Blocked filter - Replace the filter
Blocked float Incrustation on the float
- Remove the cannister lid and safety device
and extract the float. Continue by carrying
out the cleaning procedures as described in
the paragraph, "CLEANING, SANITISATION,
DISINFECTION, STERILISATION"
Vacuum power poor and/or non-existent
Vacuum adjustment knob completely open
- Fully close the adjustment knob and check
the vacuum power
Blocked protection filter - Replace the filter
Connecting tubing to the filter and device
clogged, bent or disconnected
- Check the condition of the tubing, replace
it if blocked and correctly connect it as per
the "ASSEMBLY DIAGRAM" of this manual
Cannister lid overflow valve closed or
blocked - Unblock the overflow valve, keeping the
device upright
Dirty, blocked or damaged pump
- Take the device to your trusted dealer or
an authorised FLAEM service centre
If, after checking the above-described conditions the device is still not working properly, we recommend taking it to your nearest
trusted dealer or authorised FLAEM service centre.
CANISTER HOLDER
For convenience, the canister holder can be detached and reattached on the most suitable side (left or right) as shown
in the figure:
Using a tool, unfasten the canister holder from the bottom of the
device and rotate it in order to release it.
Refasten it, using the inverse procedure, on the selected side.
Ensure that the canister holder is properly fastened to the bot-
tom of the device. This system allows up to two canister holders
to be connected.