EN | User manual
Article:
54513
Read the user`s manual completely and carefully. It is part of the product and includes important information for proper installation and
use.
Keep this User's manual for clarification and only pass it on together with the product.
Safety Instructions
Risk of life by electric shock!
>>
Avoid contacting mains voltages!
>>
Relevant electric knowledge required!
>>
In doubt, consult an electrician.
Features
Direct and indirect AC and DC Test of 12-220V, Displays 12 / 36 / 55 / 110 / 220V, Ground, Broken line, Inductance Break-point-Test
Intended Use
This device is useable for direct and indirect voltage and continuity measurements in AC and DC live circuits. To use this, relevant electric
knowledge according is required.
Bedienelemente
Direct Test - button
Inductance Break-Point Test button
LCD
Continuity measurement
Housing
Probe
Display
The last displayed value is the correct one.
Example: For 220V, also the other voltages are displayed, too.
Is the displayed value only 70% of the actual one, it should be the lower range of the peak value.
Direct AC measuring
>>
When measuring a line, press „Inductance Break-Point“ button.
If continuity measurement lamp is shining, it’s the phase line L.
If the lightning symbol is shining, it’s the neutral line N.
If is nothing displayed, it’s the Earth wire or a not connected line.
>>
Press „Direct Test“ to display the phase voltage.
Indirect AC measuring
>>
Hold the probe on the isolation of phase L.
>>
Press „Inductance Break-Point Test“.
The lightning symbol is displayed.
If dissapearing, a broken line is possible.
DC measuring
Attention! Do this only with very low voltages like car batteries!
>>
Touch one Pole with your hand, the other one with the probe.
>>
Press „Direct Test“.
Disposal Instructions
According to the European WEEE directive, electrical and electronic equipment must not be disposed with consumers waste. Its
components must be recycled or disposed apart from each other. Otherwise contaminative and hazardous substances can pollute our
environment.
As a consumer, you are committed by law to dispose electrical and electronic devices to the producer, the dealer, or public collecting points at the
end of the devices lifetime for free. Particulars are regulated in national right. The symbol on the product, in the user`s manual, or at the packaging
alludes to these terms. With this kind of waste separation, application, and waste disposal of used devices you achieve an important share to
environmental protection.
REV201
5
-0
6
-0
3
V
2
Fixpoint®
by Wentronic GmbH
Pillmannstraße 12
38112
Braunschweig
Germany
