RMD802 - RMD802BH
| Owner’s manual
11
Short press SEL button on the front of receiver and channel nubmer will be increased gradually from 00-99. Once channel
number reaches 99, recycle to 00 and count again.
Long press SEL button for 3 seconds to enter to pair mode between receiver and transmitter.
Long press SEL buttton for 10 seconds to start scanning amtomatically to choose the clean channel and then enter pair-
ing mode.
Placing the transmitter within 30 cm from the front of the receiver with the transmitter’s IR window facing the IR trans-
mistion on the front panel of the receiver.
Press and hold the SEL button on the front of receiver to enter pair mode, at that time frequency code flashes and then
stop flashing upon transmitter paired with receiver successfully. Simultaneo usly the READY LED will light green.
Turn on your connected amplifier or mixer, but keep the
volume all the way down. Set the Level CH1 knob on the
receiver fully clockwise. This is unity gain. Speak or sing
into the microphone, or if you are using the transmitter
with a connected instrument, play the instrument at normal
performance level. Slowly raise the volume of your amplifier
or mixer until the desired level is reached.
If you find the system has noticeable dropouts, reduced
overall working range, or unexpected noise bursts, change
the operating channel of the system using the steps above.
ANT.A
ANT.B
POWER
LEVEL CH2
CH1C
H2
IR
READY
SEL
AF
READY
SEL
AF
LEVEL CH1
ANT.A
ANT.B
POWER
LEVEL CH2
CH1C
H2
IR
READY
SEL
AF
READY
SEL
AF
LEVEL CH1
ANT.A
ANT.B
POWER
LEVEL CH2
CH1
CH2
IR
READY
SEL
AF
READY
SEL
AF
LEVEL CH1
