Owner’s manual |
EVE
sERIEs
professional mixer
Owner’s manual |
EVE
sERIEs
professional mixer
5
ENGLISH
INsTALLATION
Be sure that there is enough space around the unit to comfortably work and even for cooling purposes,
to avoid over-heating. Don’t place your mixing console on high-temperature devices such as radiators
or power amps.
EVE console is connected to the mains via the supplied adapter cable. Please use only the adapter
provided with the console, this adapter complies with all the applicable safety standards. First connect
the adapter cable to the console, then connect the cable plug to the mains, finally turn on the console.
Please note that all units must be properly grounded. For your own safety, you should never remove
any ground connector/device from electrical devices or power cables, or make them inactive. Please
ensure that only qualified people install and operate the mixing console.
OpERATIONs
All EVE console levels should be at minimum; so checks that all knobs and fader (if any) are at -
∝
. If a
level is raised please move it to -
∝
position, preventing in this way any noise which could damage your
speakers and headphones connected. set EQ, PAN and BAL knobs at center-detent position.
With you amplifiers/active speakers turned off, start making connections. Using XLR cables connect your
microphones, activating PHANTOM power switch for all microphones requiring such power. Connect
line level sources using balanced or unbalanced 1/4” TRs or Ts cables. Connect the analogue I/O of
your tape recorder/CD player to CD/TAPE RCA connectors. Connect your headphones to PHONEs 1/4”
stereo jack, FX sEND to external FX unit, MAIN OUT to your FoH sound system/studio monitors/audio
board, and (if present in your console) CTRL ROOM OUT to your studio monitors.
Now you can turn on your EVE console and raise MAIN MIX knob/fader to “0”. Immediately after you
can turn on your sound system, and begin to set all the levels. In order to achieve best signal-to-noise
ratio for all inputs, we suggest following procedure. Mono channel: set the LEVEL knob at “0” then raise
the TRIM knob until when louder signals drive Master section output LED around “0”, double checking
even if CLIP LED is lit. stereo channel: set the LEVEL knob at “0”, then press the +4/-10 sensitivity switch
(not in EVE5), while checking with louder signals Master section output LED ladder. If the signal is too
hot, please depress the sensitivity switch, setting it to +4 position. CD/TAPE connections have no level
control, so you’ve to adjust the level from source output level knob/fader.
