5
There should now be a continuous bead of
lubricant on the flat surface under the Treadbelt,
all the way across the width of the area where the
Treadbelt makes contact. This should consume
one full tube of lubricant.
6
Now, turn on the treadmill and walk on it for
several minutes. The action of the belt moving
will smear the lubricant over the contact surface and the belt. Please note that
it may take a couple of days of normal use for the large belt to become fully
lubricated. Repeat the lubrication process as required.
Care and Cleaning Instructions for your Treadmill:
Important:
Do not clean or wipe under the walking belt.
Daily:
Wipe moisture from the control console and treadmill surfaces if needed.
Weekly:
You should wipe down your treadmill once a week with a water
dampened, soft cloth. Be careful not to get excessive moisture between the
edge of the overlay panel and the console, as this might create an electrical
hazard or cause the electronics to fail.
Monthly:
Clean dust and dirt that might accumulate under and behind your
treadmill once a month. Small rubber particles from the soles of walking shoes
will accumulate alongside the belt and also behind the unit.
Every Six Months:
If the Walkstation is being used on a very thick, plush carpet,
dust and fibers my accumulate inside the motor compartment at the front of the
treadmill. Consider an underlayment under the treadmill so that it is not sitting
directly on the carpet, or else have qualified service personnel vacuum out the
motor compartment.
Expert Service:
Expert service and maintenance at a reasonable cost are
available through your factory-trained, authorized dealer. The dealer maintains
a stock of repair and replacement parts and has the technical knowledge to
meet your service needs. Contact your local Steelcase dealer for service.
Due to the risk of electric shock,
the motor compartment should only be opened by qualified
service personnel.
W
A
R
N
I
N
G
5
WS_Care&Maintenance:Layout 1 1/7/10 11:00 AM Page 5
