A4
Aa3
A4
A4A
A4A
Aa3
Aa3
Aa3
A3
A2
B
A15
Aa4
A5
Aa4
A4
A4
Step 5
Attach two Legs (A4) to the Top Ba
r (A2B)
using four Binder Post and Bolt Sets (Aa3). On the
Opposite side, Attach two Padded Legs (A4A) to the Top Bar and Legs Support (A3) using four
Binder Post and Bolt Sets (Aa3). Then tighten all Binder Post and Bolt Sets (Aa3) using the 5mm
Allen Wrench provided.
NOTE: The Padded Legs (A4A) must be installed on the same side as the Basketball Hoop
(B3).
Step 6
Slide a Crossbar Cap (A15) over each end of the Slide Mounting Bar (A5). Connect the Slide
Mounting Bar (A5) to the two Legs (A4) using two Binder Post and Bolt Sets (Aa4). Tighten the
Binder Post and Bolt Sets (Aa4) using the 5mm Allen Wrench and 5mm Allen Wrench with
Phillips Screwdriver provided.
NOTE: The Slide Mounting Bar (A5) is the bar with 2 holes through the center. This will be used
to attach the Slid
e (Z8) i
n later steps.
19
ASSEMBLY
B3
