www.fi shman.com
3. Carefully separate the bag from the Velcro patch.
To set the adhesive, burnish the entire area of the
patch, especially the edges.
4. Install a 9V alkaline or lithium battery. Tuck the
battery into the bag and re-attach to the Velcro
patch. The adhesive under the Velcro patch requires
24 hours to achieve a full bond, so take care to not
stress the adhesive if you remove the battery bag
after the initial installation.
Second pickup source option
A second source such as a microphone or magnetic
soundhole pickup may be added (fi gure 3). The
output will appear on the ring connection when a
tip-ring-sleeve ¼” jack is inserted.
For specifi c wiring diagrams, refer to fi shman.com.
Specifi cations
Power Supply:
9 Volt alkaline battery
Battery Life:
2,000 hours
Maximum Output
Voltage:
4V peak to peak
Input Overload:
-.7dBV
Input Impedance:
10MOhms
Output Impedance:
Less than 5kOhm
System Gain:
3dB
Signal-to-Noise Ratio: 94dB
Discrete Component
Design:
FET low noise class A
input stage, bipolar class
AB output stage
REV. 2.3
PJ FISHMAN
+
G
IN
R
-
Pickup Signal
to “IN”
2nd Pickup Signal
to Ring (“R”)
Pickup Shield
to Ground (“G”)
2nd Pickup Shield
to Ground (“G”)
Figure 3
514-300-114 Rev A 5-09
