This pin is an electronically controlled switch and has no signal on it. It can share a
switch contact with other voice select wires without interaction.
Note: the Single Coil / Voice-3 select pin (3) over rides Voice-2 select. Therefore, the
Voice-3 pin must be disconnected (not grounded) to allow Voice-2 selection.
3. Single Coil / Voice-3 Select Wire - To select Voice-3, connect this pin to ground
through a switch contact.
In Single Coil mode, the default active coils are the inner ones when used as a Bridge/
Neck pair. (i.e. neck side coil active on Bridge pickup and bridge side coil active on
Neck) See Note (4) to change default active coils in Single Coil mode.
When selected, Single Coil / Voice-3 mode over rides the status of Voice-1 or 2.
4. Single Coil Mode Select - A row of three solder pads is used to select the active coil
in Single Coil / Voice-3 mode
7
