9. Wiring the Switchjack
1. Gently bend back the strain relief/sleeve tab to gain better access to the Tip ter-
minal.
2. Solder the "hot" signal wire (red) to the Tip terminal, which is the shortest of the
three tabs.
3. Solder the black neg. battery wire to the Switch terminal (longest tab).
4. Solder the shielding to the Sleeve tab on the jack. Gently tighten the strain
relief.
See Pages 9 through 11 for more wiring options with the Switchjack.
10. Fasten the Jack in the Endpin Hole
Follow this sequence when installing the endpin jack:
1 - First Large Hex Nut
2 - Large Dress Washer
3 - Star Washer
4 - Guitar Endblock
5 - Small Dress Washer
6 - Small Dress Nut
7 - Strap Button
The jack should protrude at least 5/16" and no more than 11/32" outside of the gui-
tar body for proper fit.
After fitting the small dress washer and nut over the end of the jack, insert the 3/32"
Allen wrench through the small hole on the end of the jack. Tighten the nut with the
1/2" open end wrench while holding the jack in place with the Allen wrench. Thread
and hand tighten the the strap button.
Note: With the strap button in place, the end of the jack
should protrude slightly so that when a plug is inserted, it
will snap securely into place.
7
7
I n s t a l l a t i o n G u i d e
I n s t a l l a t i o n G u i d e
2 3
4
5
6
7
1
