Page 4
For technical questions, please call 1-888-866-5797.
Item 62675
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Set Up
1. Use a coin to open the Battery Cover and
remove from unit. Observing polarity, insert 4 AA
batteries into the unit. Replace Battery Cover.
4 x AA Size
OPEN
Figure A
2. Insert the 3-Pin Adapter on the Transducer
Cable into the receptacle on the base of the
unit, taking care to align the pins properly. Attach
the Bracket to the unit using the two screws.
3. Attach the Float to the Transducer Cable. Pull out
the rubber Stopper to adjust the length of Transducer
Cable between the Transducer and the Float. The
length should be at least 15-25 cm (6"-10").
3-Pin
Adaptor
Transducer Cable
Bracket
Figure B
4. Use fishing rods (not included) to guide Transducer
to desired position and tighten Cable.
Figure C
5. Add additional floats (not included) to the Cable to
keep it floating on the water’s surface. Do not allow
cable to be “hooked” by underwater rocks or debris.
Figure D
