Lit. No. 95026, Rev. 01
7
March 15, 2018
7197‑1
9.
Trim any portion of the handles protruding through
the frame openings.
10.
For all vehicles:
Measure the distance between the mounts
as shown below. This distance should be
30‑1/8" ± 3/16". Once the proper distance
is achieved, tighten the cross bar fasteners
according to the torque chart.
Tighten the M10 stabilizer bracket cap screws and
all remaining fasteners according to the torque
chart. Start at the front of the mount and work
rearward.
11.
Notch the lower plastic portion of the bumper as
needed to accommodate the snowplow mounts
and snowplow. Reinstall using original vehicle
fasteners.
NOTE: After five to ten hours of snowplow usage,
retorque all pushplate assembly fasteners.
7.
On vehicles without compatibility brackets:
Clamp the rear of each mount tightly against
the bottom of the truck frame. Using the bottom
mount hole as a guide, drill a 17/32" diameter hole
through the bottom of the frame rail.
8.
Trim the handle of a 1/2" x 1‑1/2" cap screw with
handle to 1‑1/2" long, as shown. Insert it into the
opening in the side of the frame rail and through
the 17/32" drilled hole in the bottom of the frame.
Loosely fasten with a 1/2" locknut.
Using the 11/16" diameter mount holes as guides,
drill an 11/16" diameter hole through the outer wall
of each frame rail.
Insert a 5/8" nut with handle through the opening
in the side of each frame rail and align with the
drilled holes. For each of the mounts, insert a
5/8" x 1‑1/2" cap screw through both the mount
hole and drilled hole in the frame rail, and thread
into the 5/8" nut with handle.
CAUTION
Before drilling any holes, check both sides
of the material for any wires, fuel lines, fuel
tanks, etc., that may be damaged by drilling.
30-1/8" ± 3/16"
Outside to Outside
Not to scale
