Lit. No. 43069, Rev. 05
7
May 1, 2019
86000, 86000-1, 86100(CH), 86100-1(CH), 86200, 86205, 86205-1, 86300, 86400
86600-3, 86610-3(CH), 87000, 87000-1, 87100, 87200, 87300, 87400, 87600-3
T-FRAME TO BLADE ASSEMBLY
1.
For 7.5'/8.5'/9.5' Blades:
Remove the blade wings
from the crate. Remove the four shipping straps,
then replace the cutting edge hardware.
For 10.5' Blades:
Remove the blade wings from
the crate. Remove and discard the hardware
from inner and outer ribs that are bolted to the
crate. Remove the hardware that connects the
cutting edge to the crate, then use the hardware to
assemble the cutting edge. Discard the crate after
installation.
2. Align the hinges of each wing. Position the
T-frame assembly between the blade wings so
that the holes in the T-frame are aligned with the
holes in the wing hinges.
3. Insert the pivot pin from top to bottom through all
the hinges as shown below.
Pivot Pin
1" x 4-3/4"
Clevis Pins
1/4" x 1-1/2"
Cotter Pins
9.5' XV2™ Blade Shown
4. With the snowplow in normal operating position,
lower the jack to support the headgear. Release
the jack lock to hold the jack in position.
5. Remove the protective packaging from the
angle rams.
6. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
blade.
7. Install a 1" x 4-3/4" clevis pin from the top down
to attach each rod. Secure the clevis pins with
1/4" x 1-1/2" cotter pins.
Jack Handle
Jack Lock
Jack
