November 5, 2003
6
Lit. No. 26182
27750 LD
6. Install a 3/8" U-bolt through the last link in one end
of the lift chain. Attach U-bolt and chain to the
holes on the driver-side of the A-frame with two
3/8" lock washers and nuts. Tighten. The other end
of the lift chain will pass through the stop link on
the lift arm and then be attached to the passenger-
side of the A-frame after hydraulic unit is installed.
7. Insert the cable down through the hole in the strap
fork. Attach the strap fork to the hole in the stop
link on the lift arm with a 3/8" x 1" clevis pin and
1/8" x 1" cotter pin. Slip the cable thimble onto the
top loop in the spring previously installed in the
front of the A-frame.
NOTE: The slotted end of the thimble may need to
be opened to slip it onto the loop. Fully close the
slot after attaching the thimble to the spring.
Vi
ew
from
bottom
of
A
-
frame
.
Cable
Clevis Pin
Strap Fork
Cotter Pin
Stop Link
8. Loop the end of the cable around the thimble. Pull
the cable up against the thimble until the slack is
removed. Attach the end of the cable back onto
itself with two cable clamps loosely installed close
to the thimble as shown.
Due to varying vehicle heights, the length of the
cable must be adjusted for the vehicle in the Final
Adjustments section at the end of these
instructions.