Lit. No. 43766/43768, Rev. 01
16
November 1, 2017
WIRING AND HARNESS INSTRUCTIONS
ACCESSORY LICENSE PLATE LIGHT
If the accessory License Plate Light Kit is not
installed,
coil and cable‑tie the brown wire away from
any hot, sharp, or moving parts.
To install the accessory License Plate Light, follow
the instructions included with the kit.
CENTER HIGH‑MOUNTED STOPLIGHT
(CHMSL)—GAS & HYDRAULIC MODELS
An LED center high‑mounted stoplight is standard
equipment on all stainless steel hopper spreaders.
The orange wire from the vehicle harness is for the
CHMSL. Splice the orange wire into an existing
CHMSL circuit wire tap. Location of the tap varies
according to specific vehicle model, and may be
located either in the cab or in the rear of the vehicle.
Always use the tap provided by the OEM.
DO NOT splice the orange wire into the wire coming
off the stoplight switch by the brake pedal. Splicing at
the stoplight switch may affect transmission shifting,
cruise control, or other vehicle functions.
Gas Engine Installations
1. Cut the tape holding the orange wire where it exits
the convoluted tubing.
2. Pull out the orange wire to the location of the
vehicle CHMSL tap. Cut a small V notch in the
tubing for the wire to exit. Pull the wire through the
V notch and tape the tubing on each side of the
exit point.
3. Trim any excess length from the orange wire and
splice the wire into the vehicle tap.
Hydraulic Drive Installations
1. Route the vehicle CHMSL/Parking Lights harness
from the battery to the rear of the vehicle.
2. Attach the 5/16 ring terminal to the NEGATIVE
post of the battery.
3. Cable tie the harness away from any hot, sharp, or
moving parts.
4. Tap the orange CHMSL wire into the vehicle's
CHMSL circuit at either the rear or front of the
vehicle.