7
3
Toy Bar
• Loosen the screw in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment door.
• Insert one "AAA" (LR03)
alkaline
battery into the
battery compartment.
• Replace the battery compartment door and tighten the screw.
• If the toy bar begins to operate erratically, you may need to reset
the electronics. Remove the battery and reinstall.
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removeable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Battery Safety Information
Battery Installation
To prevent serious injury or death:
•
Fall Hazard
- Never use on any elevated
surface, since child’s movement may cause
product to slide or tip over. Use only on
a floor.
•
Suffocation Hazard
- Never use on a soft
surface (bed, sofa, cushion) since product
can tip over and cause suffocation in
soft surfaces.
• Never use as a carrier or lift while child is
seated. Never use toy bar to carry product.
• Always use the restraint system.
• This product is not intended to replace a cot
or bed for prolonged periods of sleep.
• Never leave child unattended.
• Do not use product once child can sit unaided.
WARNING
Restraint Belts
Securing Your Infant
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the restraint belts to the restraint pad.
Make sure you hear
a “click” on both sides
.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
Restraint Pad
1
Setup and Use
