5
Assembly
• Turn the frame upright.
• Insert the fork post up through the hole in the neck of the
frame.
Make sure the fork is positioned so that the fork
covers face the rear wheels.
• Place the handlebar over the fork post and push it down
onto the frame. Make sure the handlebar is positioned so
that the screw hole faces the rear wheels and aligns with
the screw hole in the fork post.
Hint:
You may need to rotate the handlebar to align
the holes.
• Insert the #8 x 3" (7,6 cm) screw through the hole in the
handlebar and into the fork post. Tighten the screw with a
Phillips screwdriver. Do not over-tighten.
Handlebar
Frame Neck
Fork Post
Fork Cover
Rear of Trike
• Position the seat upside down.
• Fit the small pegs on the seat retainer into the holes in
the seat.
• Insert and
“snap” the cap into the hole in the frame.
Cap
Seat Retainer
Seat
Peg
Holes
9
10
11
12
• Make sure the areas where the labels will be applied are
clean and dry. Wipe your vehicle with a clean, soft, dry
cloth to remove any dust or oils.
• For best results, avoid applying a label more than once.
• Apply the labels as shown in the illustration above.
(Label
6
on other side)
(Label
2
on other side)
8
3
5
5
1
4
7
