background image

Note:

 For best performance, we recommend replacing the 

batteries that came with this trike with three, new "AA" (LR6)

 

alkaline

 batteries.

Headlight Cover

•  Loosen and remove both screws from the headlight cover. 

Remove the headlight cover.

•  Loosen the screw in the battery compartment door. Open 

the battery compartment door.

•  Insert three "AA" (LR6) 

alkaline

 batteries.

•  Close the battery compartment door and tighten the screw.
•  Replace the headlight cover. Replace the screws

and tighten.

•  When sound or lights become faint or stop, it's time for an 

adult to replace the batteries. We recommend the use of 
alkaline batteries for longer battery life.

•  If this product begins to operate erratically, you may need 

to reset the electronics. Slide the power switch off and then 
back on. 

(United States Only)

This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and 
can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference 
to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the 
following measures: 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment 

and receiver. 

• Consult the dealer or an experienced radio/TV technician 

for help.

Note: Changes or modifi cations not expressly approved by 
the manufacturer responsible for compliance could void the 
user’s authority to operate the equipment. 
This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) 
this device may not cause harmful interference and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.

FCC Statement

In exceptional circumstances, batteries may leak fl uids that can 
cause a chemical burn injury or ruin your product. To avoid 
battery leakage:
•  Do not mix old and new batteries or batteries of different 

types: alkaline, standard (carbon-zinc) or rechargeable 
(nickel-cadmium).

•  Insert batteries as indicated inside the battery compartment.
•  Remove batteries during long periods of non-use. Always 

remove exhausted batteries from the product. Dispose of 
batteries safely. Do not dispose of this product in a fi re. 
The batteries inside may explode or leak.

•  Never short-circuit the battery terminals.
•  Use only batteries of the same or equivalent type, 

as recommended.

•  Do not charge non-rechargeable batteries.
•  Remove rechargeable batteries from the product 

before charging.

•  If removable, rechargeable batteries are used, they are 

only to be charged under adult supervision. 

Battery Replacement

Battery Safety Information

7

Battery Compartment

•   Protect the environment by not disposing of this 

product with household waste (2002/96/EC). Check 
your local authority for  recycling advice and 
facilities (Europe only).  

1,5V x 3

“AA” (LR6)

1

2

Summary of Contents for T8822









Reviews: