7
Setup and Use
To prevent serious injury or death:
•
Fall Hazard -
Never use this product on an
elevated surface, since child’s movement may
cause the product to slide or tip over. Use
only on a floor.
•
Suffocation Hazard -
Never use on a soft
surface (bed, sofa, cushion) since the
product can tip over and cause suffocation in
soft surfaces.
• Never leave child unattended.
• Never use as a carrier or lift while child
is seated.
• This product is not intended to replace a cot
or bed for prolonged periods of sleep.
• Use the upright position (toddler mode) only
when child has developed enough upper
body control to sit without leaning forward.
• Always use the restraint system until
child is able to climb in and out of the
product unassisted.
• Do not use reclined position (infant mode)
once child can sit unaided.
• Never use toy bar as a handle.
WARNING
Infant - Recline
Kickstand
Kickstand
• Rotate the kickstand out for a stationary feeding seat.
• Push down on the seat bottom to be sure the kickstand
is in position.
2
Waist Belt
Restraint Pad
Restraint System
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the waist belts to each side of the restraint pad.
Make sure you hear a “click” on both sides.
• Tighten each waist belt so that the restraint system is snug
against your child. Please refer to the next section for
instructions to tighten the waist belts.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
3
Waist Belt
Seat Position
• Fasten the straps on the back of the pad for the
Infant-Recline Position
.
1
BACK VIEW
