Assembly
6
Hubs
Seat Frame Tubes
Plastic
Housing
Press Buttons
8
• Insert a screw into each hub
and each seat frame tube.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Seat Frame Tubes
Hubs
Insert Screws
9
#8 x 1
1
/
4
" Screw – 2
Shown Actual Size
• Decide which side of the reversible pad you will use. One
side of the pad has a soft, cotton material with ruffle (for
swing use); the other side is a wipeable vinyl material (for
high chair use).
• Fit the pocket on the back of the reversible pad onto the
seat back.
• Insert the crotch restraint through the large rectangular
opening in the pad.
10
Crotch
Restraint
Pad
• Position the frame assembly so that the curved, front base
is towards you.
• Fit the seat frame tubes into the hubs on the frame
assembly.
• Press the upper buttons on the seat frame tubes and insert
them into the hubs on the frame assembly until they
“snap”
into place.
Make sure you hear a “snap” on both sides
.
• Fit the waist restraints through the smaller slots in the
reversible pad.
• Fasten the fasteners on the sides of the reversible pad to
the back of the seat.
• Fit the bottom edge of the reversible pad around the bot-
tom edge of the seat.
Assembly is now complete.
IMPORTANT! Before first-time use, please read and under-
stand how to install batteries, setup, use, store and care
for Swing ‘n Meals
™
.
11
Waist Restraints
Fastener
Fastener
79739b-0920.qrk 10/25/01 11:11 PM Page 6
