Seat
Lock Fastener
Battery
Clamp
Hole
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery in
the battery compartment. Make sure the battery connec-
tor extends toward the rear of the vehicle.
• Make sure a Power Wheels
®
25 amp fuse, in good condi-
tion, is installed in the battery.
• Fit one end of the battery clamp into the hole in the bat-
tery compartment.
• Insert the #8-18 x
7
/
8
”
screw through the end of the bat-
tery clamp and into the vehicle body. Tighten the screw
with a Phillips screwdriver. Do not over-tighten.
19
Battery Installation
H
IMPORTANT! Use only a Power Wheels 6 Volt (4.0 Amp/Hr.)
battery with a 25 amp fuse installed. Use of any other battery
or fuse will damage your vehicle. Make sure that you charge
the battery for at least 18 hours using the enclosed Power
Wheels
®
6 Volt (4.0 Amp/Hr.) charger before operating your
vehicle for the first time. Charge the battery for at least 14
hours after each use of the vehicle. Never charge the battery
longer than 30 hours. Failure to follow these instructions may
damage your battery and will void your warranty.
• To unlock the lock fastener, use a
slotted screwdriver to rotate the lock fastener
1
/
4
turn to
the unlocked position
.
1
2
3
6 Volt
Battery
• Plug the battery connector into the
motor harness connector.
Note: if the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
• Re-assemble the seat to the vehicle.
IMPORTANT! Always remember to keep the lock fastener
locked at all times to prevent children from accessing
the battery.
Lock Fastener
LOCKED
Lock Fastener
UNLOCKED
Summary of Contents for POWER WHEELS 74230
Page 31: ...31...
