5
• Bend the “T” end of the plug and insert it into the hole in the base.
Note:
After assembly is complete, fi ll the base with water or approximately
50 lbs. (22.7 kg) of sand (water and sand not included) to keep this product
stationary. Simply lift the plug, fi ll the base, and replace the plug.
Plug
“T” End
Base
• Position the base as shown.
• Position the upper post so that the straight end is down and the curved end
is up and facing away from the base.
Hint:
For easier assembly, apply liquid soap or rub a candle or bar soap
around the bottom of the upper post (especially on the corners) and the inside
of the large square opening. If assembling inside, place a tarp under the base
to protect the fl oor surface.
• Insert the upper post into the large square opening in the base and, using a
circular motion, push it all the way down.
• Hook the rectangular tab on each side of the rim to the upper post,
as shown.
• Rotate the rim down until it snaps into place on the upper post. Push down
on the rim to be sure it is secure.
4
5
6
Large Square Opening
Base
Upper Post
Curved End
4
5
6
Rectangular Tab
Rim
Upper Post
ASSEMBLY
ASSEMBLY
ASSEMBLY
5
6
7
6
4
5
Backboard
Labels
Peg
Groove
Wall
Rim
Upper Post
• Lean the rim against a wall for support.
• Locate the pegs on each side of the rim and the grooves on the backboard.
• Position the backboard with the label side facing up.
• Place your foot on the base to hold it steady and slide the backboard onto
the upper post at an angle, as far as it will go.
Note:
There should be no gap between the upper post and the backboard.
• Move the assembly away from the wall.
8
