background image

2

3

fisher-price.com

X0480

Please keep this instruction sheet for future reference,

as it contains important information.

Requires three “AA” batteries (included) for operation.

Batteries included are for demonstration purposes only. 

Adult assembly is required. Tool required for battery replacement: 

Phillips screwdriver (not included)

Wipe this toy with a clean, damp cloth. Do not immerse. 

This toy has no consumer serviceable parts.

Do not take apart.

Additional play pieces shown in the photo are sold

separately and subject to availability.

Parts

Roof (Inside House)

Part not shown: 2 Label Sheets

4 Figures

Oven

2 Stools

Table

Sink

Couch

Bed

Stairs

Roof (Inside House)

House

•  Grasp the tab on the second floor and lower to open the house.

•  Locate the roof inside the house. Slide the roof out of the side of the house.

Assembly

1

2

Roof

Tab

fisher-price.com

p

(

)

Wipe this toy with a clean, damp cloth. Do not immerse.

This toy has no consumer serviceable parts.

Do not take apart.

Additional play pieces shown in the photo are sold

separately and subject to availability.

  WARNING

CHOKING HAZARD 

– 

Small parts. Not for 

children under 3 yrs.

Summary of Contents for DORA the EXPLORER X0480

Page 1: ...ay pieces shown in the photo are sold separately and subject to availability Parts Roof Inside House Part not shown 2 Label Sheets 4 Figures Oven 2 Stools Table Sink Couch Bed Stairs Roof Inside House House Grasp the tab on the second floor and lower to open the house Locate the roof inside the house Slide the roof out of the side of the house Assembly 1 2 Roof Tab fisher price com p Wipe this toy...

Page 2: ... States Only This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions m...

Page 3: ... the tabletop onto the bump on the table base Push to snap the other side onto the table base Fit the top peg up into the hinge and then push to fit the bottom peg into the floor Fit the top peg up into the hole in the front wall and then push to snap the bottom peg into the floor Tip the door so that the top peg is outside of the house Fit the bottom peg into the indent in the floor Lift the door...

Page 4: ... LR6 alkaline batteries Locate the battery compartment on the bottom of the dollhouse Loosen the screw in the battery compartment door and remove the door Remove the exhausted batteries and dispose of them properly Insert three new AA LR6 alkaline batteries Replace the battery compartment door and tighten the screw Do not over tighten If this toy begins to operate erratically you may need to reset...

Reviews: